DELLNER BUBENZER

JHS-PC 3X65

JHS-PC 3X65

A passive yaw sliding bearing with  a robust yet simple design that guarantees optimum performance throughout the life of the turbine. As few components are needed, this bearing is reliable and virtually maintenance free, so there’s less need for outages or downtime.  Brake torque is applied continuously and the system slides on the yaw bearing, so you don’t need an additional brake disc.  The brake torque is mainly dependent on surface pressure and friction coefficient, so variations can be built in during the design process

  • Fully closed passive brake system
  • Special epoxy resin pads
  • Min / Max working temperature -40c / + 70c

Additional PRODUCTS

DELLNER BUBENZER's Anti Sway Systems allow the damping of head-block, spreader and container oscillation generated by acceleration / deceleration of trolley and gantry.

BAC

The BAC-brakes is used for stopping and/or holding of fans, blowers, wind turbines, coilers, crane slewing and travel gears etc.

BHB

Band Brake for large torque applications that can be used for emergencies or back up braking needs. Band Brakes have been around for many years and we offer many ways to operate via thruster, air, hydraulic or hand wheel.

The BOSS® system has been developed based on the experience with the SOS system that has been already installed in more than 200 container cranes world wide.

The BCMS-4 is a micro-controller-based monitoring and switching device for spring applied brakes of the SFB and KFB series.

The Brake Control Unit BCU 2001 records characteristic current and voltage variations, which are induced by movements of the armature disk in the magnetic field of the brake coil.

These brakes are for parking utilization, securing the crane against the wind force. In emergency condition they can be operated also as dynamic brakes to stop the crane. They are hydraulic powered with HPU or BUEL® G.

Designed for all rail mounted equipment, like cranes, stackers, reclaimers, etc. Direct holding of idle wheels, particularly where rail clamps or rail brakes cannot be used.

The high capacity of these brakes makes them particularly suitable as service- or secondary emergency brakes e.g. on hoists, slewing drives and belt conveyors.

The BUEL® Model G is a new family member of the DELLNER BUBENZER brand BUEL®. It is a compact thruster to feed active or passive hydraulic brakes and emergency brakes.

The BUEL® Model H is a family member of the DELLNER BUBENZER brand BUEL®. BUEL® thrusters are used for almost all kind of industrial applications.

The BUEL® Model S is a brand new family member of the DELLNER BUBENZER brand BUEL®. It is designed for wheel brakes on rail mounted cranes, where high pulling forces for mechanical wheel brakes are required.

Compact status monitoring system for a brake system with display and fieldbus interface.

Compact status monitoring system for a brake system with display and fieldbus interface.

Compactus is a pneumatically operated hydraulic pump system that multiplies pneumatic line pressure into hydraulic pressure that is sufficient to operate pressure applied disc brakes at rated capacity.

These brakes are for parking utilization, securing the crane against the wind force. In emergency condition they can be operated also as dynamic brakes to stop the crane.

These brakes are for parking utilization, securing the crane against the wind force. In emergency condition they can be operated also as dynamic brakes to stop the crane.

DELLNER BUBENZER's DBSB is a storm safety brake for all rail mounted equipment, e. g. cranes, stackers, reclaimers etc.